ZY6192型鹵酸氣體釋出測定裝置試驗機
Type of halogen acid gas release measurement device testing machine
一、概述An overview of the
ZY6192型鹵酸氣體釋出測定裝置用于測定低鹵和無鹵阻燃電纜的鹵酸氣體總量和用測量PH值和電導率來測定氣體的酸度，其設計符合GB/T17650.1-1998、GB/T17650.2-1998和IEC60754.1-1998、IEC60754.2-1991標準，同時滿足GB/T19666-2005《阻燃和
耐火電線電纜通則》標準中表6的規定和GA306.1-2007第6.3.4條、GA306.2-2007第6.3.4條、UL2556-2007第9.10和9.11條要求。此設備測試、結構合理、操作簡單，為電線電纜制造商、各大專院校、商檢部門及科研單位提供方便。
ZY6192 type halogen acid gas release measurement device used to measure low halogen and halogen-free flame
retardant cable halogen acid gas volume and gas is measured by measuring the PH value and conductivity of
acidity, its design accord with GB/T17650.1-1998, GB/and IEC60754.1 T17650.2-1998-1998, IEC60754.2-1991
standard, at the same time meet the GB/T19666-2005 standard for the general principles of the flame-retardant
and fire-resistant wire and cable said six rules and GA306.1-2007 article 6.3.4, article 6.3.4, UL2556
GA306.2-2007-2007-9.10 and article 9.11 requirements. The test precision equipment, reasonable structure,
simple operation, for wire and cable manufacturers, colleges and universities, commodity inspection
departments and scientific research units to provide convenient.
二、主要技術參數The main technical parameters
1、管形爐：加熱腔有效長度及管徑600×φ50mm，裝配有一個可調電氣加熱系統，其加熱功率為6KW（AC220V）
2、燃燒管：材質為石英玻璃，內徑為36mm，在管形爐進口側伸出的長度為60mm~200mm，在出口側伸出的長度為60mm~100mm，
留有間隙供熱膨脹使用。
3、燃燒舟：材質采用熔凝石英管，長80mm，寬25mm，深10mm。
4、氣體的收集：采用兩個洗瓶，其中一個配有磁力攪拌器，并且盛有220mL的氫氧化鈉溶液。
5、供氣系統：
6、取樣：500mg ~1000mg
7、鹵酸含量的測定：
8、電源：AC220V，50HZ
9、外形尺寸：L1632mm*W602mm*H860mm
1, the tubular furnace heating cavity effective length and diameter 600 x 50 mm, equipped with an adjustable
electric heating system, the heating power is 6 kw (AC220V)
2, combustion tube: is made of quartz glass, inner diameter is 36 mm, in the length of the tubular furnace
inlet side out of 60 mm to 200 mm, the export side out of 60 mm to 100 mm, the length of the gaps heating
expansion.
3, combustion boat: material using fused quartz tube, 80 mm long, 25 mm wide, deep 10 mm.
4, gas collection: the two washing bottle, one of them is equipped with a magnetic stirrer, and sodium
hydroxide solution containing 220 ml.
5, gas supply system:
6, sampling: 500 mg to 1000 mg
7, the determination of halogen acid content:
8, power supply: AC220V, 50 hz
9, appearance size: W602mm L1632mm * * H860mm
三、電源：控制試驗機電的通斷。Power supply: the test of mechanical and electrical on-off control.
報警：Warning:
①在加熱過程中，當實際溫度超過所設溫度時，該蜂鳴器便會報警提示，此時需點擊試驗控制主畫面上的“報警復位”鈕，以
停止報警；
②當達到所設時間時，該蜂鳴器也會報警提示，此時需點擊圖6界面上的“報警復位”鈕，以停止報警。
流量調節：此流量計用于記錄及控制試驗時石英玻璃管內的空氣流量。
空氣壓力調節：此旋鈕用于調節試驗時石英玻璃管內的空氣壓力。
攪拌器電源：用于控制磁力攪拌器電源的通斷，當其上的指示燈亮時，則說明磁力攪拌器通電。
攪拌器加熱：打開此開關，磁力攪拌器上洗瓶中的液體溫度會慢慢上升。
攪拌器調速：轉動此旋鈕，以控制磁力攪拌器上洗瓶中磁力攪拌棒的旋轉速度。
可程式控制器：用于對試驗的整體控制及監測。
(1) in the process of heating, when actual temperature more than set temperature, the buzzer will alarm
prompt, now need to click the test control "alarm reset" button on the main screen, in order to
Stop alarm;
(2) when to set the time, the buzzer will alarm prompt, now need to click the "alarm reset" button on the
interface of figure 6, to stop the alarm.
Flow control: the flow meter is used to record and quartz glass tube air traffic control trial.
Air pressure adjustment: this knob is used to adjust the air pressure of quartz glass tube when testing.
Agitator power: is used to control the magnetic stirrer power on and off, when the indicator light on the
shows magnetic stirrer electricity.
Heating mixer: turn on the switch, magnetic stirrer of the washing bottle liquid temperature will rise slowly.
Stirrer speed: turning the knob, to control the washing bottle on the magnetic stirrer in the rotation of the
magnetic stir bar.
Programmable controller: designed for testing the overall control and monitoring.
四、試驗相關資料Test data
試驗步驟
1、將稱重至0.1mg的處理過的試樣放在燃燒舟中，并使其均勻地分布在燃燒舟的底部。
2、然后把燃燒舟送入置于管形爐的燃燒管中。
3、用針形閥把空氣流量調節為（0.015D2）L?h-1±10%，并在試驗期間維持恒定。
4、然后在（40±5）min內均勻升溫，并在（800±10）℃溫度下保持20min。升溫速率和試樣溫度應用適當的方法作檢驗。
注：確認升溫速率和試樣溫度的范例如下：
作為預備試驗的鑒定程序，應用上述規定的空氣流量，把熱電偶或其他適當的溫度測量設備（適當防腐），放在空的燃燒舟中
的試樣點上，進行空白試驗。通過這個試驗可制定出一套重復使用的升溫規則，來保證實際試驗時能達到要求的試樣升溫速率
和溫度。
5、拆開洗瓶，把內容物倒入1000ml量瓶中。并用蒸餾水或軟化水沖洗洗瓶、連接管和燃燒管的終端（冷卻后），把沖洗液也
倒入量瓶中，然后追加至1000mL。
6、取出燃燒舟后，整個管子必須在950℃溫度下煅燒以清凈之。鹵酸含量的測定冷卻至環境溫度后，用吸管或滴定管量取
200mL溶液到燒杯中，依次加入4mL濃硝酸，20mL的0.1M硝酸銀和3mL硝基苯。充分搖動內容物使氯化銀凝聚析出。
然后加入1mL含幾滴6M硝酸的濃度為40%的硫酸鐵銨水溶液，混合后在磁力攪拌下用0.1M硫氰酸銨滴定。
鹵酸總量以每克試樣的氯化氫的毫克數表示如下：
Test steps
1, weighing accurate to 0.1 mg of the processed samples in the combustion boat, and make it evenly distributed
in the bottom of the combustion boat.
2, and then sent combustion boat in a tubular furnace combustion tube.
3, the air flow control with needle valve for (D2) 0.015 L? H - 1 + / - 10%, and to maintain a constant during
the test.
4, then evenly within (40 + 5) min to heat up, and in (800 + 10 ℃ temperature keep 20 min. Heating rate and
sample temperature appropriate method for inspection.
Note: confirm an example of heating rate and sample temperature is as follows:
As a pilot study of the identification procedure, application of the rules of the air flow, the thermocouple
or other appropriate temperature measuring device (appropriate anticorrosive), on the empty sample point in
the combustion boat, blank experiment was carried out. Through the experiment can develop a set of reusable
heat up rules, to ensure that the actual test can meet the requirements of sample heating rate and
temperature.
5, open washing bottle, pour the contents into 1000 ml volumetric flask. Using distilled water or
demineralized water wash bottles, connecting pipe the combustion tube and the terminal () after cooling, the
rinses also in volumetric flask, and then add to 1000 ml.
After 6, take out the combustion boat, the pipe must be calcined at 950 ℃ temperatures to clean. The
determination of halogen acid content after cooling to ambient temperature, or through a straw burette
measuring 200 ml solution into a beaker, in turn, add 4 ml of nitric acid, 20 ml of 0.1 M nitric acid silver
and 3 ml of nitrobenzene. Fully rocked the condensation of silver chloride precipitation in contents.
Then add 1 ml contains a few drops of 6 M nitric acid concentration of 40% aqueous solution of ammonium ferric
sulfate, mixed with 0.1 M under magnetic stirring ammonium thiocyanate titration.
Halogen acid amount per gram sample of hydrogen chloride mg number representation is as follows:
五、注意事項Matters needing attention
1、在進行操作時，一定要做好防護措施，如戴口罩、手套等，以免影響身體健康。
2、此設備僅適用于單相220V交流電源。
3、試驗機在使用時必須可靠接地，否則有觸電危險。
4、此設備必須安置在干燥的室內環境中，以免潮濕銹蝕設備。
5、為延長試驗設備的使用壽命，應定期給試驗機通電。
6、每次試驗結束后，都要及時地關閉電源，清理試驗現場，保持設備清潔。
1, in operation, must be protective measures, such as wearing masks, gloves, etc., so as not to affect the
body health.
2, this equipment is only applicable to single-phase 220 v ac power.
3 when use, testing machine must be reliable grounding, or get an electric shock risk.
4, this equipment must be placed in dry indoor environment, in order to avoid moisture rust equipment.
5, to prolong the service life of the testing equipment, should be regularly to the testing machine
electricity.
6, every time after the test, all want to turn off the power supply in a timely manner, clean up the test
site, keep the equipment clean.
本頁產品地址：http://www.521uz.com/sell/show-4360130.html
免責聲明：以上所展示的[ ZY6192 鹵酸氣體釋出測定裝置試驗機]信息由會員[東莞中諾臺灣質檢儀器設備有限公司]自行提供，內容的真實性、準確性和合法性由發布會員負責。
