| 提交詢價信息 |
| 發布緊急求購 |
Anritsu MG3633A 0.01-2700MHz合成信號發生器
MG3633A具有優越的頻率解析度，頻率切換速度，信號純度，和高輸出電平，另外還有振幅，頻率和相位調制功能。還有載波頻率，輸出電 平，和調制頻率掃描功能，所以精確掃描可被多種設備檢測。l MG3633A具有一個頻率存儲區可存儲1000個載波頻率和一個功能存儲區可存儲100個面板設置。其zui大輸出電平為+17dBm，可與多種信號源連接 使用.
| Carrier frequency | Range | 10 kHz to 2700MHz | ||
| Resolution | 0.01Hz | |||
| Accuracy | Same as that of the reference oscillator | |||
| Internal reference oscillator*^1 | Frequency:10MHz Start-up characteristics:After 30 minutes of operation:≤1*10^-7/day, after 60 minutes of operation: ≤5*10^-8/day, Aging rate :After 24 hours of operationL≤2*10^-8/day, Temperature characteristics: ±5*10^-8/day (0° to 50℃) | |||
| External reference signal input | 10MHz,TTL Level,BNC connector on rear panel | |||
| Reference signal output | 10MHz,TTL Level,BNC connector on rear panel | |||
| Switching time | ≤10ms (time form last command until frequencyhas stabilized to within ±500Hz of set frequency,during remote operation) | |||
| Output | Range | -143 to +23dB | ||
| Units | dBm,dBμV,V,mV,μV,(Terminated and open voltages are selectable for dBμV,V,mV,or μV) | |||
| Resloution | 0.1dB | |||
| Frequency response | ±0.5dB referred to 0 dBm (<1280MHz),±1dBreferred to 0 dBm(≥1280MHz) | |||
| Accuracy | Output level\ Frequency | 10kHz to <1280MHz | ≥1280MHz | |
| +1701 to +23dBm | - | - | ||
| +15.1 to +17dBm | ±1dB | - | ||
| -122.9 to +15dBm | ±1dB | ±2dB | ||
| -132.9 to -123 dBm | ±3dB | ±4dB | ||
| -143 to -133dBm | - | - | ||
| Impedance | 50Ω,N-type connector VSWR:≤1.5(<1280MHz,≤-3dBm)≤1.8(≥1280MHz≤-3dBm) | |||
| Switching time | Time form last command until output levelis stabillzed ,during remote operation:≤25ms(at LEVEL NORMAL mode) ≤5ms (at LEVEL CONTINUOUS mode) | |||
| Interference radiation | ≤1μV(Value is voltage terminated with 50Ωload ,measured 25 mm form oront panel with a two-turn 25mm diameter loopantenna )Except sweep mode | |||
| Signal purity | Spurious | At+7dBm CW mode:(fc: carrier frequency) | ||
| Harmonics(2nd,3rd):≤-30dBc(at ≥100kHz) Sub-harmonics(fc/2,3fc/2,5fc/2):None(at <1280MHz)≤-30dBc(at ≥1280MHz) Non-harmonics: ≤-80dBc(fc <640MHz;≥10kHz offset) ≤-74dBc(640MHz≤fc<1280MHz≥10kHz forrst ≤-68dBc(fc ≥1280MHz,≥10kHz offset) | ||||
| SSB phase noise | At+7dBm,CW mode,0° to 35℃ | |||
| Offset frequency | 1kHz | 20 to 300kHz | ||
| 0.01 to <40 MHz | -116dBc/Hz | -140dBc/Hz | ||
| 40 to <300MHz | -119dBc/Hz | -145dBc/Hz | ||
| 300 to <600MHz | -113dBc/Hz | -143dBc/Hz | ||
| 600 to <1100MHz | -107dBc/Hz | -140dBc/Hz | ||
| 1.1 to <2.4GHz | -101dBc/Hz | -132dBc/Hz | ||
| 2.4 to <237GHz | -97dBc/Hz | -120dBc/Hz | ||
| Floor noise:≤145 dBc/Hz(40 to <110MHz) | ||||
| Residual AM | ≤0.02% rms at ≥150kHz(demodulation band:300Hzto 3kHz) | |||
| Residual FM | ≤0.8Hz rms at <1280MHz(demdulation band:300Hz to 3kHz) ≤4Hz rms at <1280MHz(demdulation band :300Hz to 3kHz) | |||
| Ampli- tude modul- ation | Range | 0 to 100% | ||
| Resolution | 01% | |||
| Internal modulation frequency | Fixed frequency:400Hz,1kHz Variable frequecny:0.1Hz to 50 kHz ,0.1Hz resolution Frequency accuracy:100 ppm | |||
| Accuracy | ±(5% of indicated value+2%)[at ≥250kHz ,≤+7dBm,0 t 90% and internal 1kHz | |||
| At ≤±7dBm±1dBbandwith | ||||
| Lower modulation frequency limit | 20Hz(EXT AC mode),DC(EXT DC mode) | |||
| Upper modulation frequency limit | Carrier frequecny\ Modulation factor | 0 to 30% | 30.1 to 80% | |
| 0.25 MHz ≤fc<0.5MHz | 5kHz | 5kHz | ||
| 0.5 MHz ≤fc<80MHz | 20kHz | 10kHz | ||
| 80MHz≤fc | 50kHz | 20kHz | ||
| External modulation | Input level:Approx.2 Vp-p 600Ω Input Impedance:Nominal 600Ω | |||
| Depth | ≤1%(at≥1MHz≤+7dBm internal 1kHz 30%z) ≤3%(at≥1MHz≤+7dBm internal 1kHz 80%) ≤ 3%(at 250kHz≤fc<1MHz ≤+7dBm internal 1kHz 30%) ≤10%( at 250kHz≤fc<1MHz ≤+7dBm internal 1kHz 100%) | |||
| Incidental FM | ≤200Hz peak(at ≤250kHz+7dBm internal 1kHz30%) | |||
| Fre- quency modu- lation | Range | 0 to 400kHz(1MHz ≤fc<40MHz) 0 to 100kHz(40MHz ≤fc<80MHz) 0 to 200kHz(80MHz ≤fc<160MHz) 0 to 400kHz(160MHz ≤fc<320MHz) 0 to 800kHz(320MHz ≤fc<640MHz) 0 to 1.6,MHz(640MHz ≤fc<1280MHz) 0 to 3.2MHz(1280MHz≤fc) | ||
| Resolution | 10Hz (0 to 9.99 kHz deviation) 100Hz (10 to 99.9kHz deviation) 1kHz (100 to 666 kHz deviation) 10kHz (1 to 3.2 MHz deviation) | |||
| Internal modulation frequency | Fixed freqeuncy:400Hz ,1kHz Variable frequency:0.1 to 100kHz 0.1Hz resolution Frequency accuracy:100ppm | |||
| Accuracy | ±(5% of indicated valeu+20Hz)[internal 1kHz) | |||
| Modulation frequency response | ±1dB bandwidth Frequency range :20Hz to 100kHz(EXT AC mode )DC to 100kHz (EXT DC mode) | |||
| External modulation | Input level :Approx.2 Vp-p/600Ω Input impedance:Nominal 600Ω | |||
| Distortion | ≤1%(internal 1kHz 3.5kHz deviation) | |||
| Incidental AM | ≤4%(internal 1kHz 22.5 kHz deviation,demodulationband 0.3 to 3kHz) | |||
| Carrier frequency accuracy in DC-FM mode | ±500Hz for 30-minute period after calibrationand 2-hour warm-up(at <1280MHz,<10kHz deviation) | |||
| Phase modul- ation | Range | 0 to 80 rad (1MHz ≤fc<40MHz) 0 to 20 rad (40MHz ≤fc<80MHz) 0 to 40 rad (80MHz ≤fc<160MHz) 0 to 80 rad (160MHz ≤fc<320MHz) 0 to 160 rad (320MHz ≤fc<640MHz) 0 to 320 rad (640MHz ≤fc<1280MHz) 0 to 640 rad (1280MHz ≤fc) Besiees radian,deg unit is also possible for phase deviation display.However,mzs.999deg | ||
| Resolutin | 0.01 rad (0 to 9.99 rad deviation) 0.1 rad (10 to 99.9 rad deviation) 1 rad (100 to 640 rad deviation) | |||
| Internal modulatio frequency | Fixed freqeuncy:400Hz ,1kHz Variable frequency:0.1 Hz to 5kHz 0.1 resolution Frequency accuracy:100ppm | |||
| Accuracy | ±(10% of indicated valeu+20Hz)[internal1kHz modulation] | |||
| Modulation frequency response | ±1dB bandwidth Frequency range :20Hz to 5kHz(EXT AC mode )DC to 5kHz (EXT DC mode) | |||
| Externulation | Input lievel:Approx.2 Vp-p/600Ω Input impedane:Nominal 600Ω | |||
| Distortion | ≤(internal 1 kHz 5 rad modulation) | |||
| Intemal modul- ation signal | Frequency range | 400 Hz ,1kHz,(fixed oscillator) 0.1Hz to 100kHz (variable oscillatior) DC voltage signals equivalent peak values of internal modulationg sine wavecan be applied as a modulationg singnal using the SPECLAL FUNCTION. | ||
| Resolution | 0.1Hz | |||
| Frequency accuracy | 100ppm | |||
| Distion | ≤0.03%(fixed,400Hz and 1kHz)≤0.3%(variable20Hz to 50kHz) | |||
| Memory function | Frequency memory | 1000 carrier frequencies(store /recall) | ||
| Funcition memory | 100 panel settings(store/recal) | |||
| Sweep mode | Carrier freqeuncy ,output level,AF frequency | |||
| Sweep tunc- tion | Sweep time | 0.1 ms to 600s ,0.01ms resolution(minimumtime depends on the switching time of each function.) | ||
| Other func- tions | Marker | One movable marker | ||
| Sweep signal output | Staircase (saw-tooth waeform ),Start point:0V,Stop point:100V) | |||
| Modulation signal output | Modulation signal is outputwhen modulationg Output level:Approx.2 Vp-p/600Ω | |||
| Relative value display | Carrier frequency,output level | |||
| Continuouly variable output level mode | Continuousltyvariable within a±10dB rqngeof the set level Step size:0.1dB | |||
| Trigger function | Previously programmed operation procedurecan be started by a trigger input through its input termibal(on reqr panel,BNCconnector,TTL level)Maximum program steps for triggereed operation:99 steps | |||
| Memory backup | Last settings are stored when pwer is turnedoff | |||
| GPIB | Interfacce function:SH1,AH1,T5,L3,TE0,RL1,PP0,DC1,DT1,CO | |||
| Reverse power | Maxium reverse input power:50W (<100MHz)25W(≥1000MHz)±DC50V | |||
| Operating- temperatur | 0 °to 50℃ | |||
| Power | *7Vac+10 -15%48 to 63 Hz ≤270VA | |||
| Dimensions- and mass | 426(W)*177(H)*451(D)mm≤32kg | |||
| EMC*^8 | EN55011:1991,Group 1, Class A EN50882-1:1992 | |||
| Safety | EN61010-1:1993(Instalation Category II PollutionDegree II) | |||
免責聲明：以上所展示的[ MG3633A Anritsu MG3633A 0.01-2700MHz合成信號發生器]信息由會員[]自行提供，內容的真實性、準確性和合法性由發布會員負責。
